What Size Hole Is Needed For Installing the Furrion Marine Power Inlet
Question:
What is the correct size hole that’s needed for installation?
asked by: Nick
0
Expert Reply:
The Furrion Marine Power Inlet # F30ITSBS requires a hole cutout of 2-1/2".
The easiest way to get the 2-1/2" cutout would be to use a 2-1/2" hole saw. If you do not have a 2-1/2" hole saw, the Light-Duty Hole Saw Set # PT34VR has a variety of hole saw sizes including 2-1/2".
expert reply by:
Scott S
0
Products Referenced in This Question
Light-Duty Hole Saw Set with Carry Case - Carbon Steel - 16 Pieces
- Hand Tools
- Cutting Tools
- Drill Bits
- Hole Saws
- Carbon Steel
- Performance Tool
more information >
Product Page this Question was Asked From
Furrion Marine Power Inlet - 30Amp - 125V - LED - Square - Black
- Marine Power
- Power Inlet
- 30 Amp Female Plug
- 30 Amp to 30 Amp
- 30 Amp Male Plug
- Black
- Furrion
more information >
Continue Researching
- Shop: Furrion Marine Power Inlet - 30Amp - 125V - LED - Round - Gray
- Q&A: Will The SumoSprings Solo Custom Helper Springs # SSR-121-54 Fit a 2024 Ford Transit 350?
- Q&A: Where To Connect The Red Wires Of The Progressive Dynamics RV Power Center # PD4135K
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Where Does The White Wire On The Back Of The Progressive Dynamics PD4135K Get Wired To
- Q&A: What Does Progressive Dynamics RV Power Control Center with AC/DC Panel use as Main Breaker
- Q&A: Wire Gauge for Progressive Dynamics Power Control Center
- Q&A: Where to Connect Negative Side of Battery to 35 Amp Progressive Dynamics RV Power Control Center
- Q&A: How to Hook a Cargo Trailer Up to Shore Power
- Article: Trailer Tire Sizing
- Article: The Best Boat Bumpers
- Article: Trailer Wiring Diagrams
- Article: 2023 Holiday Must Haves
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure the Bolt Pattern of a Trailer Wheel