Suspension Enhancement For 2003 Winnebago Adventurer on Workhorse W22 Chassis

Question

Question:

Ive owned an 03 33 ft. winne Adventurer for80k miles. All 4 leaf spring sets have lost their arc. There is no clearance on the rubber jounces which are OE. Would appreciate your expert repairs \remedy advice

asked by: Bill

0

Expert Reply:

We don't have any repairs we can offer for flattened leaf springs, with the best thing we can offer being suspension enhancement (this won't replace your leaf springs, so you'll need to get those, but the suspension enhancement can help). I believe a 2003 Winnebago Adventurer is on a Workhorse W22 chassis though you'll need to verify that as there aren't records going back that far I can find, but if so you can use SumoSprings to help support your rig, allowing you to stay level and help stop sway and body roll. The correct fit for the W22 chassis are the following:

- SumoSprings Maxim Custom Helper Springs - Rear Axle # SSR-280-54-1

- SumoSprings Solo Custom Helper Springs - Front Axle # SSF-280-47

expert reply by: Kyle S

0

Answer 1

For the Chevrolet "Workhorse" chassis that your motorhome sits on we will need to determine which of four model series it could be. This can be determined by looking at the 6th character of the VIN. "A" is the W24 chassis…

view full answer...

Answer 2

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 3

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 4

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Suspension Enhancement For 2003 Winnebago Adventurer on Workhorse W22 Chassis

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching