Weight of MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways

Question

Question:

How much does part # MR26RR weigh?

asked by: Peter M

0

Expert Reply:

The MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways part # MR26RR weigh around 38 lbs.

expert reply by: Conner L

0

Answer 1

For a mounting bracket width of 25" we only have a one-step RV Step #SMFP-1100. What you can do instead is install an a fold-down step like the MORryde StepAbove RV Steps - 2 Steps Item #MR26RR. It fits a doorway width of 23-3/4" -…

view full answer...

Answer 2

I spoke with MORryde and they really don't recommend going lower than 25" on the entry height. If this is only an issue a small portion of the time you could kind of dig out the ground around the feet of the MORryde StepAbove RV Steps…

view full answer...

Answer 3

I spoke with MORryde since the STP-017 is an OEM number and everything we offer is aftermarket and was found that that number should relate to the MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways #MR26RR. I would just measure…

view full answer...

Answer 4

The Timbren Trailer Suspension Enhancement System for Underslung Axles #T92MR is 5-1/4" tall. Timbren recommends The spring be in constant contact with the frame at all times. So ideally you will want exactly 5-1/4" from your axle tube to…

view full answer...

Answer 5

The Wolf Pups sit pretty close to the ground. You are likely at the cusp of 2 steps is not enough and three steps may be too many. To measure for replacement steps, first measure the "entry height" which is the height from the ground to the…

view full answer...

Answer 6

For you 2016 R-pod trailer I recommend the Lippert Manual Pull-Out Step for RVs - Double - 7" Drop - 24-1/4" Wide - Steel - 300 lbs #LC432682. This is 25-1/2 inches wide at the mounting bracket with two 24 inch steps. It will have a 7 inch…

view full answer...

Answer 7

To replace your Iota IDP-240 you'll want to use the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8. This panel is rated for 50 amp service, can provide both 120v/240v and is compatible with…

view full answer...

Answer 8

Hey Vitaly, so the STP-017 part number you mentioned is the OEM version of our MORryde StepAbove part number part #MR26RR which we do have replacement legs for with the part #MR36DR.

view full answer...

Answer 9

Since your door way width is 24 inches measured from flange to flange the correct MORryde StepAbove is the part #MR26RR. The part #MR86RR is for a smaller doorway width.

view full answer...