Length Of Jack Wiring Included In Lippert Ground Control 3.0 5TH Wheel Leveling Kits
Question:
Good morning! Since Lippert made and Atwood level legs can one use the already routed cable for the new 3.0 system?? If not how long is the new cable and are they pre terminated?? Is the control board pre wired with plug n play and will it work in the old spot??
asked by: Tom H
Expert Reply:
You will need to run wiring for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System 4-Point # LC358590. While Lippert did acquire Atwood the wiring for the 2 systems is different. This includes 2 front harnesses which are 14' long and 2 rear harnesses which are 35' 4" long. These are all pre-terminated connectors for connecting the jacks to the control module. The only wires not terminated are the power wires for the control module. If you are needing the 6-Point System # LC675817 It will include 2 of the 14' long harnesses for the front landing gear and 4 of the 35'4" harnesses to run to the rear and middle jacks.
I cannot say if the control module will work in the same spot as your current module as these parts are installed by each RV manufacturer.
Products Referenced in This Question
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Dimensions of Lippert Ground Control 3.0 Jacks For Clearance on Keystone Cougar 28SGS
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)