Troubleshooting Screen Not Working of Lippert Ground Control
Question:
Lights up but no words. I’ve unplugged to reset and same thing. No corrosion seen.
asked by: Tifany P
0
Expert Reply:
If a hard reset does not bring the screen back of your Lippert Ground Control # LC358590 you'd need to replace it with the part # LC421484.
expert reply by:
Jameson C
0
Products Referenced in This Question
Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Control Panel
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Replacing Electric Landing Gear on 5th Wheel Trailer with Auto-Leveling System
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review