LED Clearance Light Recommendation for a Trailer that Wont Illuminate all of the Clearance Lights
Question:
Trying to figure out issue on trailer lights. Brake and signals work correct but tail lights dont. Marker light on back half are dim while markers on front half are bright. 3 lights in between tail lights have no power and are self grounded although there is ground coming out of the loom that the power wire comes from for these three lights and when I touch it to ground these three light develop a dim light while the back markers get even dimmer.
asked by: Mitch
Expert Reply:
It sounds like you are overdrawing your running light circuit and you do not have the amperage to illuminate all of the running lights at the same time. You are probably on the verge of blowing a fuse on your tow vehicle so I would recommend you stop now and address the problem before you attempt to tow with this setup.
The best recommendation I can give you would be to convert your clearance lights to LEDs since they draw a fraction of what an incandescent bulb does so it should fix your overdrawing problem.
I attached a page that has all of the LED clearance lights we carry for you to check out.
Product Page this Question was Asked From
35 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 42" Ground
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 31 Feet and Longer
- Plug and Lead
- 4 Flat
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Q&A: Converting 7-Way Blade To 4-Way Flat On Trailer
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: How to Measure for Trailer Hitch Drop
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Q&A: Will Yakima HandRoll Kayak Roof Rack Fit Malone Crossbar Conversion Kit
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: What Wire Gauge is Used on the 35 ft. Wishbone 4-Way Trailer Wiring Harness, # A35W42B