Torque Specs for Terminal Screws on Furrion Automatic Transfer Switch
Question:
What is the torque spec on the power lugs?
asked by: Michael L
0
Expert Reply:
You will want to tighten the terminal screws on the Furrion Automatic Transfer Switch # F50ATS to the range of 20 - 24 in/lbs according to the Furrion instructions (linked to this answer page).
Attached is a review video for you to check out.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Furrion Automatic Transfer Switch - 50 Amp - 125/250V
- RV Transfer Switch
- 50 Amp
- 120V
- 240V
- Furrion
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Furrion Automatic Transfer Switch - 50 Amp - 125/250V
- Q&A: Wiring Diagram for Installing Furrion Transfer Switch 50 Amp Item # F50ATS
- Video: Review of Furrion RV Transfer Switch - 50 Amp Automatic Transfer Switch - F50ATS
- Q&A: Can I Use 50 Amp Transfer Switch With 30 Amp RV Setup
- Q&A: What Does Amp Rating Mean For Transfer Switch & Can 30 Amp Work w/ 50 Amp Shore Power
- Q&A: Replacement for Todd Engineering PS245S Power Switch
- Q&A: Wiring Diagram for Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger
- Q&A: Installation Instructions For The Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch
- Q&A: Fixed Side Vs. Float Side for Replacement Standard Dual Rack Repair Kit Wall Slide-Out
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: How Much Solar Power Do I Need For My RV?