Connecting Thule License Plate Holder # TH35JV To 4-Way Flat Trailer Connector Wiring
Question:
Hi, are you suggesting the 2 pin harness this comes with, can simply be attached to a 4 pin trailer harness? I guess by just leveraging the 2 pins instead of the four when plugged in? How do you keep dust and debris out of the other 2 pins not in use if thats the case?
asked by: Caleb P
Expert Reply:
Yes, you can use the Roadmaster Extension Loop # RM-300150-00 to connect to the Thule License Plate Holder # TH35JV wiring. This will leave you 2 exposed male terminals which will have power and could short out when using the turn signals and brake lights. You can protect this by covering the terminals with some Heat Shrink # DW05450 to seal away the connectors. Or so you do not have so many connections you can cut off the end connectors of the 4-way and 2-wire to connect them with Butt Connectors # DW05743-5. Then you will just have one harness with the 2 connectors versus 2 harnesses.
Products Referenced in This Question
Primary Wire Heat-Shrinkable Tubing - 14-10 Gauge - Red - 3/16" Shrink Diameter - 6" Long
- Electrical Tools
- Wire Protection
- Heat Shrink Tubing
- 3/16 Inch Diameter
- 6 Inch Long
- Red
- Deka
more information >
Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation - Red - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 22-18 Gauge
- Deka
more information >
Roadmaster Extension Loop for Towed Vehicles - Dual 4-Way Flat Trailer Ends - 6' Long
- Accessories and Parts
- Tow Bar Wiring
- Extensions
- 4 Flat to 4 Flat
- Straight Cord
- Roadmaster
more information >
Product Page this Question was Asked From
Thule License Plate Holder for Bike Racks - Lighted
- Accessories and Parts
- License Plates and Frames
- Mounting Hardware
- Brackets
- Thule
more information >
Continue Researching
- Shop: LED Trailer Tail Light w/ Reflector - Weatherproof - 4 Function - 76 Diodes - Clear/Red Lens
- Shop: Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
- Shop: Thule License Plate Holder for Bike Racks - Lighted
- Shop: Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Shop: Trailer License Plate Holder with LED Light - 3 Diodes - Clear Lens - Black Frame
- Shop: Trailer Wiring
- Shop: Yakima PlateMate License Plate Holder for Bike Racks
- Shop: LED Trailer License Plate Light with Mounting Bracket - 3 Diodes - Clear Lens - Black Frame
- Q&A: Could Triple LED Trailer Tail Light CE44VR Fit 2019 Jayco Redhawk
- Q&A: Troubleshooting LED Trailer Tail Light w/ Reflector Not Functioning After Install
- Shop: Vehicle Tow Bar Wiring
- Q&A: Parts Needed For Adding A Lighted License Plate To The Back Of a Thule EasyFold XT Bike Rack
- Video: Review of Thule Lighted License Plate Holder for Bike Racks - TH35JV
- Search Results: thule license plates and frames
- Search Results: thule
- Q&A: License Plate Mounting Bracket Solution for Ladder on Class B Motorhome
- Q&A: Tail Light and License Plate Kit Recommendation for a Kuat NV 2.0 Bike Rack
- Q&A: Tail Light and License Plate Solution for Transporting Covered Bikes
- Video: Curt Auxiliary LED Indicator Lights Review C53201
- Video: Review of Curt Hitch Cargo Carrier - Hitch Bike Rack - C53201
- Video: Yakima PlateMate Bike Rack License Plate Holder Review
- Q&A: How To Display a License Plate With a Bike Rack Attached
- Video: Roadmaster Tow Bar Wiring RM-300150-00 Review
- Shop: Trailer Hitch
- Search Results: led lights
- Search Results: tail light
- Search Results: circuit tester
- Search Results: 30717
- Search Results: 4 flat male to 4 flat male
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2022 Toyota Prius