What Resistor Should I Choose For My Incandescent Lights On My 2009 Jeep Wrangler?
Question:
how do i figure out if i need a 25 or 50watt resistor?
asked by: Brett H
0
Expert Reply:
The 25 watt Buyers Products Anti-Flicker Harness for Turn Signals # 3375621012 should be more than plenty, however to really decide between this one and the 50 watt version # ALEDRST2B, you'd need to choose the one that is closest to your incandescent light.
So if your light is closer to 25 watts, you'll want # 3375621012, and if it is closer to 50 watts you'll want # ALEDRST2B.
expert reply by:
Bryce D
0
Products Referenced in This Question
Optronics Load Resistor for LED Lights - Male PL-3 Plug and Female PL-3 Plug - Qty 1
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Aluminum
- Optronics
more information >
Product Page this Question was Asked From
Buyers Products Anti-Flicker Harness for Turn Signals - PL-3 With Male And Female Plugs
- Accessories and Parts
- Emergency Supplies
- Vehicle Lights
- Wiring Harness
- Buyers Products
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between the Load Range D and E for the Tire Size ST145R12
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: How To Switch Propane Supply on 1981 Tioga RV to 20 Pound Propane Cylinder
- Q&A: How Much Clearance is Required between Truck Cab and Trailer to Safely Make 90 Degree Turn
- Q&A: Trailer Bearing Availability with Inner Diameter of .75 inch and 1.25 inch
- Q&A: Replacement for Oil Cap 21-88 for 9K, 10K, and 12K Oil Bath Trailer Axle Hubs
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Article: 2023 Best Gifts for RVers & Campers
- Article: Trailer Wiring Diagrams