Base Pads For Scissor Style Stabilizer Jacks On a 2008 Fleetwood Mallard
Question:
The jack model #is J 5000 ,they are 9 inches in lenght and 4.5 inches wide. What snap pads will fit my 2008 mallard by fleetwood?
asked by: Charles T
0
Expert Reply:
I recommend using the Stromberg Carlson Base Pad Peak # SC58MR for the scissor jacks on your 2008 Fleetwood Mallard. Currently Snap Pad does not manufacture pads for your scissor jacks. The Stromberg pads are 8" tall reducing the amount of the jack that must be extended.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Stromberg Carlson Base Pad Peak for Scissor and Stabilizer Jacks - 3,500 lbs - Qty 4
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Leveling Blocks
- Plastic
- 3001 - 4000 lbs
- 12-3/8 Inch Lift
- 4 Jacks
- Stromberg Carlson
more information >
Continue Researching
- Q&A: What Do I Need To Repack Bearings On A 2017 Jayco Jay Feather 16XRB
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Troubleshooting A Camco Dogbone RV Surge Protector
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Base Pad for Scissor and Stabilizer Jacks
- Q&A: How To Get More Height From A Stromberg Carlson Tongue Jack
- Q&A: Capacity of Stromberg Carlson Base Pad Extreme
- Q&A: Charging a Trailer Breakaway System Battery Using the 12 Volt Circuit on a 7-Way Connector
- Q&A: Can the Breakaway Battery Be Trickle Charged During Storage
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer