Screws in the Cruiser Accessories License Plate Bracket are Too Long
Question:
The license plate mounting screws, when installed on this bracket, would pierce through the bumper. In other words, wish this bracket was significantly thicker or I could find screws that were half the length of normal license plate screws. Any suggestions?
asked by: Atul
0
Expert Reply:
A simple solution to this would be to use some washers between the screw heads and the bracket. This will shorten them up to the desired length. Otherwise shorter screws withe the proper thread type would work too. Washers and screws should both be available at your local hardware store. There are none that are specifically designed for this purpose that we carry.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Continue Researching
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Article: Finding the Right Electric Winch
- Q&A: Can the License Plate Bracket # CR79050 be Used to Adapter Smaller Wyoming Plate to Standard Holder
- Q&A: 2021 GMC Sierra LED Turn Signals Are Hyperflashing
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: Parts Needed to Install a 7-way on a 2022 Subaru Outback Wagon
- Article: How to Repair an RV Roof
- Q&A: Recommendation for Round 5-1/2 Inch Tail Light Replacement
- Q&A: Installing a 7-Way Connector on a 2020 Subaru Outback Wagon for Towing a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Basics of Tie Down Straps