How Much to Tighten Bolts on Double RV Waste Valves - Sewer Wye - Rotating - 3" Hub and 1-1/2" Hub
Question:
How tight do the bolts need to be to keep the valves from rotating? I dont want to tighten too much and break the abs but I also dont want leaks or the valves to move. Thanks
asked by: Ken
1
Helpful Expert Reply:
In regards to the Double RV Waste Valves part # TR38, you'll tighten the bolts hand tight until snug and then use your wrench another half turn or so. If you have leaks you can go back and snug them down more but you can't unbreak the plastic flanges so it's best to progressively work your way up in regards to the torque.
expert reply by:
Conner L
1
Product Page this Question was Asked From
Double RV Waste Valves - Sewer Wye - Rotating - 3" Hub and 1-1/2" Hub
- RV Waste Valves
- Sewer Wye
- Double Waste Valve - Manual
- 1-1/2 Inch Hub
- 3 Inch Hub
- Rotating Valve
- Valterra
more information >
Continue Researching
- Q&A: Can A Slide Topper Awning Be Installed On a Slide Out with Standard Awning Already Attached
- Q&A: How to Remove Old Sewage Drain Assembly to Install Valterra Double RV Waste Valves
- Q&A: Understanding Difference Between Hubs and Spigots for RV Waste Valves
- Q&A: How to Choose Correct Valterra Double RV Waste Valves Replacement
- Q&A: How To Measure To Make Sure The MORryde CRE3000 Equalizers Will Fit Your Trailer
- Q&A: Are Trailer Leaf Spring Shackles Supposed to be Angled or Totally Straight
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Availability of Replacement Hydraulic Pump for Lippert Level Up Leveling Systems 172911
- Article: Trailer Tire Sizing
- Article: The Differences Between Cam Buckles and Ratchet Straps (And Who Would Win In a Fight)
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure for Motorhome Steps