Replacement Roll Pins And Gears For Ram 10K Trailer Jacks

Question

Question:

Need roll pins for gears on 10k Ram Jack The grooved pins

asked by: Kyle F

0

Expert Reply:

For your 10K Ram Jack, you can use the Replacement Sidewind Gear Kit for etrailer and Ram Square, Direct Weld Jacks # TJD-12000-GR to replace the roll pins.

This kit also includes 2 gears, and is designed for use with the TJD-12000 series jacks.

expert reply by: Bryce D

0

Answer 1

Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.

view full answer...

Answer 2

Instead of using the Hydraulic Brake Kit #AKFBBRK-35-D which requires using 14"-16" wheels you should use the Dexter Galphorite Free-Backing Hydraulic Trailer Brake Assembly Right #T4423400 and Left #T4423500. These will fit with your…

view full answer...

Answer 3

Per Bulldog the Repair Kit #F670801 is the correct replacement ball latch for their A256 Bulldog Cast Head Coupler #BDA256C0317.

view full answer...

Answer 4

The repair kit installs as follows: The latch assembly bolt is slid through the coupler. Slip the large spring over the bolt. The under jaw comes next, followed by the square plate, the small spring washer and the lock nut. Take a look at the…

view full answer...

Answer 5

Good news! I was able to get a exploded diagram as well as a set of instructions on how to replace the rod and gears #TJD-12000-RODNUT in the #12000 Series Ram Jacks made after 2012. I have attached them to this page for your convenience. Basically,…

view full answer...

Answer 6

We have electric drum brakes rated for 4400-lb axles (and hydraulic drum brakes rated for 3750- and 5200-lb axles) but none rated for exactly 4000-lbs. For electric drum brakes in the 10 x 2-1/4-inch size for a 5th wheel the 4400-lb-rated brakes will…

view full answer...

Answer 7

Unlike costlier brands of trailer jack the entry-level Pro Series line is not supported with the same repair/replacement parts availability as with the upper tier sister brands like Bulldog and Fulton. The few parts we have available to us are shown…

view full answer...

Answer 8

To repair a Ram Series 12000 jack, like #TJD-12000SP-R2, we have the Gear Kit #TJD-12000-GR or the Replacement Rod and Nut #TJD-12000-RODNUT. Or you could need both. I just depends on what the problem is exactly.

view full answer...

Answer 9

When our installers replace a trailer hub, there isn't a set torque spec used when tightening the spindle nut. The hub is placed on the spindle, making sure the inner and outer bearings are correctly seated. The spindle nut is then run down until…

view full answer...

Answer 10

The Replacement Gear Kit for Bulldog Sidewind Jacks w/ 12,000-lb Capacity #BD500212 are not a confirmed fit for all 12K legs. I've attached a photo with measurements to help you determine if this gear kit will work for your application. The…

view full answer...

Replacement Roll Pins And Gears For Ram 10K Trailer Jacks

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching