How Many Times Does Solera Slide Topper Need to be Wound When Installed
Question:
I installed a 6 7 Solara awning on our rv a couple years ago. I had to take it off to install a new seal. One of the springs came unwound and I need to know how many turns to put on the spring to make it work again. The slideout only extends 20 inches.
asked by: Bob C
1
Helpful Expert Reply:
When installing a Solera slide topper like the # LCV000163285 that you referenced you would need to wind it 7 times to get the correct amount of tension.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Solera RV Slide-Out Awning - 79" Wide - White
- RV Awnings
- Slide-Out Awnings
- Extends 48 Inches
- 74 Inch Wide
- 75 Inch Wide
- 76 Inch Wide
- 77 Inch Wide
- 78 Inch Wide
- 79 Inch Wide
- White
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Cooper Work Series 215/75R17.5 Radial Tire w/ 17-1/2" Wheel Come Balanced
- Q&A: How to Add Tension to Solera Slide-Topper
- Q&A: How To Select The Right Awning Size For Slideout
- Q&A: How to Determine Leaf Spring For K-Z 5th Wheel Trailer With 5,200 lb Axles
- Q&A: Will Hardware Included With Solera RV Slide-Out Awning Protrude Through Trailer Wall
- Q&A: Plug-In Wire Harness For A Redarc Brake Controller In A 2022 Jeep Wagoneer
- Q&A: Selecting Solera Slide Topper For Rockwood Mini Lite 2503S
- Article: Best Ladder Racks
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Ram Trailer Tow Prep Package
- Article: Using a Portable Generator on RV
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Best Hitches for Travel Trailers (2022) - For a Smooth, Sway-Free Ride
- Article: Best Camper Jacks