Correct Wiring Harness for Draw-Tite Activator II on 2004 Ford F-250
Question:
I have a Draw-Tite II Activator I want to install in my @2004 F-250 KR 6.0L. What harness do I need to hard wire it, and where do I connect it to the truck under the dash? The brake control module has 4 wires in the back. Red, Blue, White, and Black. Thank you for your help and response.
asked by: B A
Expert Reply:
It sounds like you're looking for the custom wiring harness pigtail that will allow you to plug the brake controller into the factory port under the dash. The correct wiring harness for your 2004 F-250 would be the # 3035-S. This will connect to your Draw-Tite Activator II so you can plug it into your factory port on your truck. The plug should be located above your gas pedal, more than likely it has a gray cap covering it. If you do not have the factory plug then you will wire the brake controller directly using the existing wire on the back.
