Are There Extenders for the 24x60 etrailer Cargo Carrier for RV Bumper

Question

Question:

I really like the 24x60 entrails cargo carrier for RV bumper steel folding 500 pounds. I have a fifth wheel 2022 Courgar half ton and the bumper sits in under my Rv unit 13 inches. Would you have something that would attach to my bumper and extend out at least 15 inches that way I would have 2 inches or better from the back of my Rv. Im up for your suggestions. Thank you

asked by: Larry F

0

Expert Reply:

I do have an option for you but we don't offer any extenders for the 24x60 etrailer Cargo Carrier for RV Bumper part # e99049. If the body of the trailer extends past the frame I recommend replacing the bumper with the Mount-n-Lock Heavy-Haul'r RV Bumper part # MO94VR so you can use the Mount-n-Lock AddaBumper Extension Plates part # MO24VR which will push the bumper out further away from the body so you have more room for accessories.

expert reply by: Conner L

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Yes, the 24x64 etrailer Cargo Carrier for RV Bumper, #e83YR is the built the same as the shorter version but with an extension to increase width. From the images you attached, if you remove the spare tire, you can install the 24x40 etrailer Cargo…

view full answer...

Answer 3

The Mount-n-Lock SafetyStruts Universal Kit #MO34VR includes the Standoff Spacers #MO54VR along with drill bits and the components found in the Standard Kit #MO22FR. The standoff spacers allow for mounting on I-beams shorter than 6".

view full answer...

Answer 4

All of our cargo carriers like the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 you checked out all come with the support brackets. Currently, we do not offer the cargo carrier without the support bracets.

view full answer...

Answer 5

From how you're describing your set up, it sounds like your bumper is attached to a tube frame, and there is a way for you to install the support brackets, which are the following part number: - Mount-n-Lock SafetyStruts Universal RV Bumper…

view full answer...

Answer 6

The Safety Struts you have now on your RV frame/bumper would work well with the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 that you mentioned. You can use them instead of the brackets that come with the carrier and you'd be perfectly…

view full answer...

Answer 7

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Are There Extenders for the 24x60 etrailer Cargo Carrier for RV Bumper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching