How To Install Tekonsha Prodigy P2 Trailer Brake Controller On 2007 Chevy Avalanche
Question:
what will it take to install the P2, accessories required
asked by: Alan H
0
Expert Reply:
In order to install the Tekonsha Prodigy P2 Trailer Brake Controller part # 90885 on a 2007 Chevrolet Avalanche you simply need to use the hardwire harness that comes with the controller. This will plug into the back of the brake controller and then wire into the wires already run under the dash. I have attached an article below to assist with the wire colors.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Lift Kit Options For A 2015 Winnebago Micro Minnie 1706FB
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: Parts Needed to Install 7-Way/4-Way on 2024 Kia Telluride with LED Taillights
- Q&A: How Is Spring Bar Tension Set Up with Trailer Weight Distribution System