Can Demco Kar Kaddy X Tow Dolly Carry Weight of 2015 Honda CR-V

Question

Question:

Staff: Will your Demco part# DM9713093 be able to handle the weight of my 2015 Honda CRV weight of 3621 ibs Thank you in advance for your answer.

asked by: Lawrence G

0

Expert Reply:

Yes, since the Demco Kar Kaddy X part # DM9713093 has a weight capacity of 4,800 lbs it would easily handle the weight of your 2015 Honda CR-V that weighs 3,621 lb.

expert reply by: Jameson C

0

Answer 1

On page 9 of the manual for the Demco Kar Kaddy X Tow Dolly w/ Disc Brakes, part #DM9713093, it has an equation to use to ensure that the towed vehicle's air dam, or bottom of facia doesn't interfere with the tow dolly platform and/or tire…

view full answer...

Answer 2

The Demco Kar Kaddy X Tow Dolly with Disc Brakes #DM9713093 and Demco Kar Kaddy SS Tow Dolly with Disc Brakes #DM9713045 will not apply the brakes if you are backing up. However, according to Demco you never want to back up with the tow dolly while a…

view full answer...

Answer 3

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 6

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 7

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 10

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 11

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 12

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Can Demco Kar Kaddy X Tow Dolly Carry Weight of 2015 Honda CR-V

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching