Can Trailer Tail Light Mounting Bracket # A66PB Be Installed Upside Down
Question:
Is there a top and bottom to this bracket? It looks like there may be notches or weep holes on one side of the bracket. The reason I ask is that based on where I am seeing the wire it looks like its at the end of the bracket. I may need flip the bracket over to be able to place the wire where I need it to go through the trailer, does that make sense?
asked by: Terry
0
Expert Reply:
Mounting bracket # A66PB can be oriented however you would like. There is no top or bottom. If, during installation, you determine that you need to flip it 180 degrees there should be no problem doing so.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Gray Bracket and Single Wire Plug for Thin Line Series Trailer Clearance and Side Marker Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Gray
- Optronics
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: How Does The Buyers Products Snapper Pin 3373004987 Get Installed?
- Q&A: Recommendation to Replace Trailer Axle with 70" Spring Center and 85-1/2" Hub Face Length
- Q&A: Replacement Lens And Bulbs For Clearance Lights On 2006 Pace Journey Trailer
- Q&A: Distance From Inside Arc Area Of U-Bolt To Threads For U-Bolt Kit Mounting Kit
- Q&A: U-Bolt Kit Recommendation for a 3 inch Diameter Axle
- Q&A: Replacement Leaf Springs for 1998 Coachmen Catalina 364 TBS
- Q&A: Mounting Bracket Options for Optronics Sealed, Thin Line Clearance Side Marker Light # MC65AB
- Article: Best Bike Racks for Electric Bikes
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Hitch Receiver Sizes
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Performance Chips and Modules