Can The TowSmart SmartStep Be Adhered To Existing Rubber On The Ramp Of A Horse Trailer?
Question:
I need to add some grip to the ramp of my horse trailer. I was thinking of getting a few of these to make two rows, placing them on top of the current rubber. Do you think the would stick well? I think the horses will be able to keep their footing with these, instead of slipping down the ramp. Thanks for the input.
asked by: Dorene
Expert Reply:
Yes the TowSmart SmartStep Non-Slip Pad - Rubber w/ Adhesive Backing # 348780 will stick just fine to rubber, however to further increase the adhesion I also recommend putting a few drops of the:
-Loctite QuickTite Super Glue Gel # LT39123.
This will ensure the SmartStep does not come off or loose its adhesion when you need it the most.
Attached is an installation video of # 348780 for you to check out as well.
Products Referenced in This Question
Loctite QuickTite Super Glue Gel - Instant Adhesive - 0.14-Oz Applicator
- Lubricants Sealants Adhesives
- Adhesive
- Multi-Purpose Adhesive
- 0.14 oz
- Loctite
more information >
Product Page this Question was Asked From
TowSmart SmartStep Non-Slip Pad - Rubber w/ Adhesive Backing - 17-1/2" Long x 4" Wide
- Accessories and Parts
- Bumper
- Nerf Bars - Running Boards
- Step Pad
- TowSmart
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement For An Atwood GCH6A-10 E S RV Water Heater
- Q&A: Correct Pull Out Steps For 25.5" Mounting Bracket Width
- Q&A: Recommended Weather Resistant Non-Slip Rubber Pad For RV Steps, Bumpers, And Ladder Rungs
- Q&A: Suitability of Draw-Tite Class I Receiver Part # 24631 for 1998 Jeep Wrangler with C Channel Bumper
- Q&A: Hardware Kit for Roadmaster EZ5 Base Plates on 2017 Jeep Wrangler
- Q&A: Does eTrailer Ship to Canada
- Q&A: Correct Wiring for Optronics LED Trailer Lights # STL22RB
- Article: Performance Chips and Modules