Replacement Slipper Spring for 1973 Tennessee Boat Trailer
Question:
Good morning, I have a 1973 Tennessee boat trailer. I need 2 slipper springs. May be able to get buy with one. I have searched for the correct size and tried to make do with a longer one but no luck. The spring I need is 18 1/2 inches from the center of eye to where the spring hits the trailer. 22 1/2 inches to the end of the spring. 1 3/4 wide They are very light. 2 thin leafs. The loaded trailer weight at the axle is just below 600 lbs. If you could find the same type or something that will work I would appreciate it. Thank you,
asked by: Lenny
Expert Reply:
The closest option we have is the 1,000 axle slipper spring part # SP-178275 which is a couple inches longer than what you need as it measures 24-5/8 inches overall and 22-3/4 inches from center of bolt hole to where it attaches to suspension hanger.
So the best solution I can make is to move back your rear hanger or go with a new hanger kit part # APS3SE set at the correct dimensions and you'd be set.
Products Referenced in This Question
Single-Axle Trailer Hanger Kit for 1-3/4" Slipper Springs - 1-1/2" Tall Front
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 1-3/4 Inch
- Single Axle
- Redline
more information >
Product Page this Question was Asked From
3-Leaf Slipper Spring w/ Radius End for 1,500-lb Trailer Axles - 24-5/8" Long
- Trailer Leaf Springs
- Slipper Springs
- Radius End
- 1500 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 24-5/8 Inch Long
- Universal Group
more information >
Continue Researching
- Q&A: Replacement Oil Seal Recommendation for Dexter Hub Part # 8-285-10UC3-A
- Q&A: Option to Replace Axle With Axle-Less System on PWC Trailer
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Tire Sizing
- Article: Slipper Spring Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Are Radius End And Flat End Slipper Springs For A Trailer Interchangeable?
- Q&A: Replacement 4-Leaf Slipper Spring Measuring 25" Long
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Should Trailer Axle have Bend In it that Faces Downward
- Q&A: Replacement Slipper Leaf Spring for Triton PWC Trailer
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Best Ladder Racks