Should be A Certain Distance from Air Conditioner

Question

Question:

How far should this exhaust be away from roof top air conditioners? Is there a recommendation from Camco?

asked by: Randy L

0

Expert Reply:

That's a really good question but there isn't a set amount of distance you need to have between the outlet of the Camco Gen-Turi RV Generator Exhaust System part # CAM44461 and your air conditioner. You'd have to use your best judgment on that. In general this releases the exhaust higher than the inlets of AC units so you shouldn't have to worry too much unless it was right next to it.

expert reply by: Jameson C

0

Answer 1

Here are the inner and outer dimensions for the Camco Gen-Turi items you asked about. Part #CAM44872 – OD is 2.94 inches and ID on the small end is 2.69 inches. Part #CAM44862 – OD is 1.51 inches and ID is 1.25 inches on the flared end. No dimensions…

view full answer...

Answer 2

I reached out to my contact at Camco and the largest bushing included with the Camco Gen-Turi RV Generator #CAM44461 is 1-3/4" in diameter. To use this with your 2-3/8" exhaust you will need to take the kit along with your vehicle to a…

view full answer...

Answer 3

My contact at MaxxAir advised that there are three potential causes for the beep and no fan motion you're experiencing with your MaxxFan Trailer Roof Vent #MA00-04000K. One potential cause is that the unit was wired with incorrect polarity. Make…

view full answer...

Answer 4

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 8

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Should be A Certain Distance from Air Conditioner

Product Page this Question was Asked From

Continue Researching