Can I Swap My Lippert Ground Control 2.0 System On My 2020 Arctic Wolf 3550 To The 3.0 System?
Question:
I have an issue with my current BAL system. The mother board for my control box has two relays and a fuse going to each leg. I cannot find a replacement control box. I believe a couple relays are bad as one jack does not receive power. All others do. The fuse is good, wire connections are good. The jack works plug into another port. The BAL system does not have the hall monitor connections. Could I upgrade to the ground control 2.0? The connections to each Jack looks the same as what are on my control box. Also would I need the Lippert control pad to go with?
asked by: Chris C
Expert Reply:
I believe you're asking if you can upgrade from your Lippert Ground Control 2.0 to the Ground Control 3.0, and yes you an technically, however since none of the parts carry over you'd need full system replacement.
If you're interested in this route, the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote # LC358590.
This is a great upgrade option for your 2.0 system, and includes the control module, sensor, wiring harnesses, and mounting hardware, and also features an easy bolt-on jack installation.
Additionally, you'll want to ensure that your setup does not have more than 20' between the jacks. If there is more than 20' between the jacks, then you're going to need to use the 6-point Ground Control system # LC675817 instead.
Products Referenced in This Question
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Replacing Electric Landing Gear on 5th Wheel Trailer with Auto-Leveling System
- Q&A: Which Snappads for 2025 Entegra Aspire
- Q&A: Install Manual for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System
- Q&A: Shorter Replacement Rear Jacks For Lippert Ground Control 3.0 4-Point Leveling Increased Clearance
- Article: How to Raise Your Travel Trailer Height
- Q&A: Will The Lippert Ground Control Fit My 2020 Genesis Supreme 5th Wheel Toy Hauler?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Gooseneck to 5th Wheel Adapters
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Best RV Roof Vents