Leg Will Not Retract on Lippert Ground Control 3.0 Electric Leveling System
Question:
I have the six point LCI 3.0 electric leveling system. Last night while retracting my gear, the right rear leg would not retract. I unplugged all power to the jack and manually retracted the leg. When I try to lower the rear legs it has a right rear fault code. Any suggestions
asked by: Kerry T
Expert Reply:
Pull the power to the 6-Point Set Lippert Ground Control 3.0 Electric Leveling System, # LC675817 for at least 15 minutes in effort to reset. You do not state what the error code is that are receiving, but my first suggestion is to try and clear any error code and reset the system. Ensure your battery bank has a proper charge before doing so as this system is challenged to function without proper voltage. If error code clears and the leg will move, reset the zero point.
Here is how to set that "Zero Point" for leveling:
1. In manual mode, run the jacks to level the trailer. This is best achieved by placing a level in the center of the trailer and leveling it both front to back and then side to side. (See “Basic Jack Operation” for instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.
4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set, Power to Exit”.
5. To set the current position as the zero point, press the “ENTER” button.
6. LCD display will read “Zero point stability check”.
7. LCD display will read “Zero point set successfully” once process is complete.
8. The system will set this point as its level state and the touch pad will turn off.
Products Referenced in This Question
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review