Adjusting Pressure on HydroMax Water Pump
Question:
The answer to one of your QandAs says that the pressure can be adjusted on the HydroMax water pump. How do you adjust it?
asked by: Jim
0
Expert Reply:
While the HydroMax RV Fresh Water Pump, # P25201 can be adjusted, the Tech Rep at Valterra recommends against doing so stating that the units are set at the factory for best results.
You will want to adjust the By-Pass spring by turning the screw. Screwing the by-pass screw in will raise the pressure and unscrewing the by-pass screw counterclockwise will lower the pressure.
expert reply by:
Michael R
0
Product Page this Question was Asked From
HydroMax RV Fresh Water Pump - 12 Volt - 3 Gallons Per Minute - 55 psi
- RV Water Pump
- Diaphragm Pump
- 3.0 gpm
- 55 psi
- 12V
- HydroMax
more information >
Continue Researching
- Shop: Flow Max RV Fresh Water Pump - 12 Volt - 3.0 Gallons Per Minute - 50 PSI
- Shop: RV Bike Racks
- Q&A: Replacement For A Duraself DS-01233-M Water Pump
- Q&A: Recommended Tire Pressures For Westlake ST225/75R15 Trailer Tires
- Q&A: Parts Needed to Activate 12 Volt Charge Circuit of 7-Way on 2022 Tiffin Wayfarer on Sprinter Chassis
- Q&A: Recommended Replacement for Shurflo 4008-101-A65
- Q&A: Replacement Gas Detector for an Atwood Series 2001 LP Gas Detector
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for Shurflo 2088-422-144 Water Pump
- Q&A: Replacement for Shurflo 2088-422-174 Fresh Water Pump
- Article: RV Propane 101: How Does My RV's Propane System Work?
- Article: What is Overlanding? How to Start your Overlanding Journey
- Article: Double-Eye Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub