CE Smith Front Hanger Bracket # CE14016G Mounting Hole Dimensions

Question

Question:

How far apart are the two mounting holes? What is the center to center distance for the bolts that connect to the trailer frame?

asked by: John W

0

Expert Reply:

The CE Smith Front Hanger Bracket # CE14016G 7/16" mounting holes are 3-3/8" on center.

expert reply by: Bud M

0

CE Smith Front Hanger Bracket # CE14016G Mounting Hole Dimensions
(click to enlarge)

Answer 1

Thanks for the picture! The spring shouldn't hit the frame like yours does in the picture, so the correct solution would be to either add a longer front hanger or using a shorter spring. The correct replacement hanger will be dependent on the…

view full answer...

Answer 2

We do carry two axles that are galvanized. We offer part #CE33201GA-HUB. This is a 57-1/2 inch long hub face to hub face straight axle with 5 on 4-1/2 idler hubs. The weight capacity for this axle is 1,800-lbs. The overall beam length is 62 inches.…

view full answer...

Answer 3

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 6

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 12

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

CE Smith Front Hanger Bracket # CE14016G Mounting Hole Dimensions

Product Page this Question was Asked From

Continue Researching