Troubleshooting Lippert Ground Control 3.0 LR Error Won't Retract
Question:
Ground control 3.0. LR jack error won’t retract
asked by: Roy
Expert Reply:
On the Lippert Ground Control 3.0 # LC358590 the error you are receiving indicates either a problem at the left front jack, a hall signal issue (open ground/short, or other malfunction) or an unexpected high amperage current stall (meaning the battery stopped providing power for some reason).
To clear the error you can either fix what is causing the error such as a loose or damaged wiring harness, or follow this method:
Extend all jacks at least 6 inches. Then press and hold the retract button until the jacks begin retracting. All of the jacks should fully retract and clear the error.
If you have a 6-point system the middle jacks only operate in error mode. To engage the middle jacks you would need to press the left and right buttons simultaneously.
Check the manual for the system because some things have to be done in a certain order for the system to operate correctly. That should prevent future errors (unless there is an actual electrical or mechanical problem).
The LR jack code means your left rear jack leg is not able to be controlled by the computer of the Ground Control 3.0 basically.
It is important that once the error code has been resolved, the user of the unit must manually
retract all jacks completely before exiting the error code. If this step is not completed, the LCD will
prompt the user to complete this step as follows:
Sample Error Codes
“ERROR”
“LR JACK”
“MANUALLY RETRACT”
“ALL JACKS”
“PRESS ENTER”
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Shop: Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Dimensions of Lippert Ground Control 3.0 Jacks For Clearance on Keystone Cougar 28SGS
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)