Replacing MaxxFan 4000 Series RV Roof Vent with 7500
Question:
Looking to replace a factory installed maxxfan 4000 series with the 7500 series. Is this a drop in replacement or do I have to remove the roof mount piece. ie remove all screws and dicor or can I leave flange and screw new fan to old roof flange
asked by: JOhn
0
Expert Reply:
Since there isn't a drop-in center section replacement for the MaxxFan 7500 series RV roof vent setup you'd have to replace the entire assembly with the part # MA00-07500K.
I attached an install video for this on a similar RV for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Powered Lift
- 5 Inch
- 12V Fan
- Reversible Fan
- 14W x 14L Inch
- Plastic
- Tinted
- MAXXAIR
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Best RV Roof Vents
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Recommended AC With Heat Strip for Enclosed Trailer
- Q&A: How to Pick Out Fan-Tastic RV Roof Vent for Camper
- Q&A: Replacement AC Unit for 15k BTU Unit on RV
- Article: 2023 Holiday Must Haves
- Q&A: Do All Three Hinges Need to be Replaced with Controlled Motion RV Door Hinge
- Q&A: Can I Install a Wall Switch on a MaxxAir MaxxFan Roof Vent
- Q&A: Replacement High Pointe Microwave for 2018 Winnebego Navion 24V with a High Pointe EC028BMR
- Article: Trailer Tire Sizing
- Article: How Many Batteries Do You Need to Run RV Air Conditioner?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How Much Solar Power Do I Need For My RV?