4-1/4 Inch Tall Hanger Needed for 1-3/4 Inch Wide Double Eye Leaf Springs
Question:
Do you have 4 1/4 spring hangers for 1 3/4 double eye springs?
asked by: John P
1
Helpful Expert Reply:
We sure do! What you're looking for is the Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall # E4139 which is designed for 1-3/4" wide springs and the standard 9/16" diameter bolt.
Attached is a review video for you to check out.
expert reply by:
Jon G
1
Product Page this Question was Asked From
Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall - 9/16" Bolt Hole
- Trailer Leaf Spring Suspension
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 4-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- Redline
more information >
Continue Researching
- Q&A: What is Bolt Hole Diameter for Suspension Hanger # E4139
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Q&A: Outside Width Dimension of the Redline Trailer Hanger # E4139
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: MORryde CRE3000 or Dexter E-Z Flex Trailer Suspension Equalizers?
- Q&A: Bolt Grade of Hardware that Comes with the Suspension Kit for Tandem-Axle Trailers AP233
- Q&A: Replacement Leaf Spring for 2021 Grand Design Imagine 3250BH
- Q&A: Hanger Spacing Recommendations for a Triple Axle Trailer with 25-1/4 inch Springs
- Article: Trailer Wiring Diagrams
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Where to Position the Trailer Axle?