Wire Connections for Control Module for Lippert Electric Coach Step
Question:
Where does the black wire go
asked by: Gary B
1
Helpful Expert Reply:
When installing the Replacement Control Module for Lippert Electric Coach Step, # LC301702 the black wire gets connected for the step light.
The four pin connector is for the motor wiring harness and two pin connector is for the motor. The black wire is for the step light and green wires to ground, one grounds the chassis, the other one grounds to the steps. The purple wire is for the step light switch.
expert reply by:
Michael R
1
Product Page this Question was Asked From
Replacement Control Module for Lippert Electric Coach Step
- Accessories and Parts
- RV Steps
- Control Module
- Lippert
more information >
Continue Researching
- Q&A: Replacement for SCS/Frigette Coach Step Controller Part 202-3230
- Q&A: Replacement Parts For Malfunctioning SCS Frigette Coach Step # 733-0001
- Q&A: Replacement Parts and Wiring Diagram for Lippert Coach Steps
- Q&A: Wire Diagram for Lippert Power Steps for Troubleshooting Wiring and Power Module
- Q&A: Replacement Control Module for Coach Steps Model 202-3207
- Q&A: Lippert Steps 128980 Wont Stop Retracting and Extending
- Q&A: Is it Required to also Replace the Door Magnet Sensor when Upgrading the Controller?
- Article: Gooseneck Trailer Hitch Information and Review
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Replacement Automotive Lighting
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited