How do You Wire the Buyer's Products Pre-Wired Switch # 3376391207?
Question:
Looking to make a arrow board to fit on back of a trailer. Pre made one wont work for what we are wanting just looking for the control box. Does this switch box control the flashing does it just need power hooked up then wires ran to lights will it function properly.
asked by: Nick S
Expert Reply:
I have an answer for you. In order for the Buyers Products Pre-Wired 6-Switch # 3376391207 to work as a flashing pattern, your light bar must already be equipped with that flash pattern functionality. With that being said, since this switch is specifically made to be used with Buyers Products lights with flash patterns such as the Traffic Advisor Light # 3378894037, we cannot confirm with absolute certainty that it works with any other application.
As far as the wiring hookup, as long as the red wire is hooked up to a DC fused source, it will receive power. I went ahead and attached the wiring diagram for your convenience.
![Bob C](https://images.etrailer.com/static/images/catg/people/2465_tn.jpg)
Products Referenced in This Question
LED Traffic Advisor Light Bar - 22 Flash Patterns - Amber LEDs - Clear Lens - 37" Long
- Emergency Vehicle Lights
- Light Bar
- Surface Mount
- LED
- Wired
- 22 Flash Patterns
- Amber
- Buyers Products
more information >
Product Page this Question was Asked From
Buyers Products Pre-Wired 6-Switch Panel - 4-On/Off and 2 Momentary - Black
- Accessories and Parts
- Wiring
- Switches
- Switch Panel
- Buyers Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Flat Towing Package for 2019 Jeep Cherokee
- Q&A: How to Connect two 12 Volt Batteries and Still have 12 Volts Output