Installing Taylor Made Dock Float - 48" x 24" x 12"
Question:
Instal on dock on the water. How to, I’m not shure I can afford or able to get labor
asked by: Vwbrammer
0
Expert Reply:
Installation requires just some basic hardware for the 48" long x 24" wide x 12" tall dock float, which is the following part number:
- Taylor Made Dock Float # 36946116
Per the manufacturer you will need 3/8" x 3" long lag screws as well as 3/8" and 5/8" washers (galvanized hardware is recommended). You'll drill holes in the boards for the lag bolts, and there are mounting slots in the floats for them.
I have attached a link below to an installation video that shows exactly what you'll need to do.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Taylor Made Dock Float - 48" Long x 24" Wide x 12" Tall - Encased Foam
- Dock Accessories
- Dock Floats
- 21 - 30 Inch Wide
- 3 - 5 Feet Long
- Taylor Made
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Taylor Made Dock Float - 48" Long x 24" Wide x 12" Tall - Encased Foam
- Shop: Taylor Made Dock Float - 48" Long x 24" Wide x 16" Tall - Encased Foam
- Search Results: dock floats
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Determining BT8 or BTR Spindle on Trailer
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: How to Determine Number of Floats for Floating Dock and Where to Space Them
- Q&A: Load Range F Tires Compared to Load Range E Tires for a Dual Axle Dump Trailer
- Q&A: How Far From the Track Will the CargoSmart Folding Workbench Sit When Folded Up for Storage
- Q&A: Distance from Wall to Legs for CargoSmart Folding Workbench Brackets
- Q&A: Recommendation for Allowing Roller Bunks to Angle Correctly to Match Jet Sky Hull