B&W Tow and Stow Hitch Pin Depth for a TowTector
Question:
The shaft is a 2inch shaft for the f150 and the towtector needs at min 1.5inch of clearance. The hitch seems to be sunken under the bumper by an 1. Is there any measurements on the BandW shaft length from the pin hole to the back of the vertical area?
asked by: Ben
Expert Reply:
I went out to the warehouse and took some measurements of the B&W Tow & Stow 2-Ball Mount item # BWTS10033B. The back hitch pin hole to the weld is 4" and the hitch pin hole closest to the weld is 2-7/8" back. How far back your 2013 Ford F-150's hitch pin hole is on the receiver compared to how close it is to your bumper will determine if you have enough room for your TowTector.
Product Page this Question was Asked From
B&W Tow & Stow 2-Ball Mount - 2" Hitch - 3" Drop, 3-1/2" Rise - 10K - Black
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- 2 Inch Ball
- 2-5/16 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Matte Black
- Drop - 3 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Class IV
- B and W
more information >
Continue Researching
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Replacement Parts for Fan-Tastic Vent 8000 Series
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Parts Needed to Tow a Trailer with a 2015 Honda Pilot
- Q&A: Trailer Hitch for a 2015 Honda Pilot
- Q&A: When Flat Towing a Vehicle How Much Tongue Weight is on the Trailer Hitch
- Article: Best Ladder Racks
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size