What Prevents Camco Cam Lock # CAM44323 From Turning
Question:
what about the two sides that are straight, to keep the lock from turning. if you make a 5/8 round hole it will turn?
asked by: JULIE P
0
Expert Reply:
The two flat sides of the threaded portion of the Cam Lock part # CAM44323 are designed to prevent it from turning. If you were to drill a totally round hole this would turn unless it was tightened down a lot.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Camco Cam Lock - Straight or Offset - Thumb Operated - 7/8" Thick
- RV Door Locks
- Compartment Door
- Cam Locks
- Thumb Latch
- Keys Not Included
- Offset Cam
- Straight Cam
- 7/8 Inch Diameter
- Silver
- Camco
more information >
Continue Researching
- Q&A: Does Galeo Pro GPS Tracking Device Update Tracking Automatically
- Q&A: Thumb Latch Cylinder Measurements
- Q&A: Replacement Baggage Door Turn Latch - 1-3/8" Length and 7/8" Diameter
- Q&A: Type of Metal and Diameter of Lippert Components Baggage Door Turn Latch - 1-3/8"
- Q&A: How to Measure the Thickness of a Camco Cam Lock
- Q&A: Replacement L-Pin for Fastway e2 Weight Distribution System with 10,000 lb Trailer Capacity
- Q&A: Replacement Control Board for Dometic RV Rooftop Air Conditioning Unit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Install Tire Chains
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: Snow Tire Chains Explained: How Tire Chains Work & When to Use Them
- Article: 2023 Best Gifts for RVers & Campers
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps