Where to Find Brake Controller Stoplight Circuit on Truck
Question:
Where do you find the hot brake light to hook up a controller too on a IHC 4300 2002
asked by: Ed
0
Expert Reply:
Behind the brake pedal there is a switch that has wires ran to it that you'll need to test with a circuit tester part # PTW2993 to test all of the wires until you find the circuit that only has 12 volts when the brake pedal is pressed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting Brake Controller Installations
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Q&A: No Splice Tow Bar Lighting Kit Recommendation for 2024 Jeep Wrangler