LCI 3.0 Electronic Leveling System Retract Timeout Error

Question:

I have reset it by pushing enter and retract - and stops beeping UNTIL 5 minutes and then it repeats.

asked by: Angelina W

Expert Reply:

According to the manual for the Lippert Ground Control 3.0 # LC358590, this is indictive of a pressure leak. I recommend checking all of your hydraulic lines, and that they are not loose or leaking.

If you do notice a leak, tighten your lines, and add more hydraulic fluid and check to see if the error message goes away.

If there is not a leak or an issue with your hydraulic lines, It's more than likely a bad sensor or circuit board and will need to be replaced.

expert reply by: Bryce D