Troubleshooting Auto Leveling and Out of Stroke Errors for Lippert Ground Control 3.0
Question:
2022 Forest River Flaggstaff 826MRB Lippert Auto Leveling Out of Stroke Error 1st time out and received this error, jacks did not extend more than 12inch total Manually leveled camper. Now home and error will not clear after trying the extend all 6inch and hold retract........didnt work. now what???
asked by: Ab
Expert Reply:
According to the manual for the Lippert Ground Control 3.0 # LC358590 the "Out of Stroke" error means that your jacks have reached the max stroke length and are unable to lift, or there is an unexpected high amp current stall. You need to check that your jacks and the wiring isn't damage to solve this.
The "Auto Level Fail" error means that it's unable to level due to uneven ground or the zero point has been set incorrectly. For this you need to check that the jacks are okay and reset the zero point.
To reset the zero point you need to do the following:
1. In manual mode, run the jacks to level the trailer. This is best achieved by placing a level in the center
of the trailer and leveling it both front to back and then side to side. (See “Basic Jack Operation” for
instructions on how to manually operate the system).
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button (Fig. 1G) 5 times and then press and
release the “REAR” button (Fig. 1J) 5 times.
4. The touch pad will flash and beep and the display will read “ZERO POINT CALIBRATION ENTER to set,
Power to Exit” (Fig. 12).
5. To set the current position as the zero point, press the “ENTER” button (Fig. 1C).
6. LCD display will read “Zero point stability check” (Fig. 13).
7. LCD display will read “Zero point set successfully” once process is complete (Fig. 14).
8. The system will set this point as its level state and the touch pad will turn off.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is The Pad For The Replacement 22-1/2" Legs For The Ground Control 3.0 Welded Or Pinned In Place
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Replacing Electric Landing Gear on 5th Wheel Trailer with Auto-Leveling System
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review