Could Smaller Hole Saw be Used to Install B and W Turnoverball Gooseneck
Question:
in all the installs it looks like the whole is to big i think they should cut 3-3/4 not 4. i dont like the gap in the bed please advise thanks
asked by: Mike
0
Expert Reply:
Due to slight variances on vehicles the hole saw size for the install of the B and W Turnoverball part # BWGNRK1116-5W is designed to give a little leeway in case the holes don't line up perfectly. The hole is a little bigger so there is a chance you could get away with a smaller hole size but I would recommend the 4 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Custom Underbed Installation Kit for B&W Companion 5th Wheel Trailer Hitches
- Fifth Wheel Installation Kit
- Custom
- Below the Bed
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Air Bag Helper Springs and Compressor For a 2022 Ford F-350 Tremor With B&W Hitch
- Q&A: Recommended 24K 5TH Wheel Hitch and Under Bed Mounting System For a 2022 Ford F-350 Short Bed
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Q&A: How To Correctly Measure For A Slide Out Topper
- Q&A: Estimated Installation Time for B&W Turnoverball Underbed Gooseneck Trailer Hitch # BWGNRK1117
- Q&A: Gen-Y Gooseneck For 2024 Jayco Eagle 355MBQS With Lippert Rhino Pin Box
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Length of Mounting Post of B&W BWRVK3050 Companion 5th Wheel Hitch For Flatbed Trucks
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: How Much Solar Power Do I Need For My RV?
- Article: 5th Wheel to Gooseneck Adapters
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Stability Control for Heavy Duty Vehicles