Replacement Galvanized Hub for a 2000 Floe Pro 1 Plus Single Axle Snowmobile Trailer
Question:
Hello, I have a 2000 floe pro 100 plus snowmobile trailer and I’m looking for 2 hubs. I don’t know the size of the axle shaft. I see that you carry 2 different hubs. One for a 1inch shaft and one for 1 1/16 shaft. Could you tell me the correct hub? Also is it worth gettin them in galvanized? Thank you
asked by: Sean T
Helpful Expert Reply:
I did some research and your 2000 Floe Pro 1 Plus single axle snowmobile trailer uses a L44649 inner and outer bearing. Seeing as how these hubs are going on a snowmobile trailer and will be exposed to road salt and quite a bit of moisture I highly recommend going with the galvanized hub. You're going to want the Easy Grease Trailer Idler Hub Assembly for 2K Axles - 5 on 4-1/2 - Galvanized item # AKIHUB-545-2-G-EZ-2K. These include the Dexter E-Z Lube and etrailer Easy Grease-compatible grease cap which makes lubricating bearings fast and easy. You just remove the rubber plug to access the zerk fitting on spindle. This completely eliminates the hassle of disassembling the hub.
Products Referenced in This Question
Easy Grease Trailer Idler Hub Assembly for 2K Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Hub
- Easy Grease
- EZ Lube
- L44649
- L44649
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- etrailer
more information >
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2
- Trailer Hubs and Drums
- Hub
- Standard
- L44643
- L44643
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- Dexter
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Bearings and Hub for Malone MicroSport Trailer
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Q&A: Can Jayco Pop Up Trailer with 4 Lug Hubs be Swapped to 5 Lug Hubs
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Zerk Fitting For The UltraFab Weld-On Jumbo Steel Roller # UF48-979012
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Measuring a Trailer Tire