Measurement of Bolt Pattern for Lippert Manual Pull-Out Step for RVs, # LC432682
Question:
your step #LC432682. What is the bolt hole dimensions of the 4 mounting holes from center to center both ways
asked by: David L
0
Expert Reply:
The Lippert Manual Pull-Out Step for RV's, # LC432682, as shown in the attached product review video, has a center-on-center hole measurement of 7" and 24".
expert reply by:
Michael R
0
Product Page this Question was Asked From
Lippert Manual Pull-Out Step for RVs - Double - 7" Drop - 24-1/4" Wide - Steel - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 25-1/2 Inch Wide
- 2 Steps
- 7 Inch Drop/Rise
- No Ground Contact
- Steel
- Lippert
more information >
Continue Researching
- Q&A: Angle of Different Stabilizer Positions for Ark Drop Down Corner RV Stabilizer Jacks
- Q&A: Dimensions for the 10K Demco eZ-Latch A-Frame Trailer Coupler
- Q&A: Can ARK Stabilizer Jacks Rotate 180 Degrees
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Replacement Step Compatible with 2016 R-Pod Trailer for Low Rise
- Q&A: Dimensions of Weld-On Plate for Ark Drop Down Corner RV Stabilizer Jack Kit
- Q&A: Recommended Replacement Stabilizer Jacks For A 2011 K-Z Durango 1500
- Q&A: Overall Length of the 24" and 30" Ark Drop Down Corner Stabilizer Jacks
- Article: How to Measure for Motorhome Steps
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Trailer Lighting Requirements