Will the Third Brake Light Camera for 4.2" Monitor Wire Up To Factory Switch on 2018 Ford F-350
Question:
Can you use the existing switches in the truck in stead of the the one that comes with the camera
asked by: Roy
0
Expert Reply:
The Custom Third Brake Light Camera for 4.2" Factory Monitor part # 3460002 which is a fit for a 2018 Ford F-350 Super Duty has its own built-in toggle switch which is already wired into the harness. The toggle switch however is very basic. I don't recommend using one already on the truck but it's possible. You'd just need to make sure the switch is wired correctly and rated appropriately.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Custom Third Brake Light Camera for 4.2" Factory Monitor - Night Vision
- Accessories and Parts
- Backup Camera
- Third Brake Light
- Third Brake Light Camera
- For 4.2 Inch Factory Monitor
- GCH Automotive
more information >
Continue Researching
- Q&A: Install Instructions for Truck Bed Cargo Camera for 4.2" Factory Monitor # 3460002
- Q&A: Lift Kit Solution to Allow Fifth Wheel Trailer to Sit More Level When Towed
- Q&A: Recommended Third Brake Light Camera For 2019 Ford F-250 With Factory Reverse Camera
- Q&A: Can Slider Fifth Wheel Hitch Be Used in Long Bed Truck
- Q&A: Troubleshooting Truck Bed Camera That Splits The Screen With Truck Bed Camera And Tail Gate Camera
- Q&A: Will Truck Bed Cargo Camera For 2019 Ford F-250 Super Duty Be Blocked By Toolbox
- Q&A: Could Custom Third Brake Light Camera kit part # 3460002 Fit 2017 Ford F-250
- Article: Performance Chips and Modules
- Article: Gooseneck Trailer Hitch Information and Review
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: Replacement Automotive Lighting
- Article: Stability Control for Heavy Duty Vehicles