Fit of 2 Inch Hitch Ball for Curt Class I Trailer Hitch
Question:
Ive got this hitch picked out for my 2005 Passat Wagon w/4Motion but Im not sure which ball to get. I know I need a 2 ball for my trailer but the specs for the hitch dont say anything about shank diameter, length, or max ball mount width. So, can I get the short shank 2 ball # 19258 for this ball mount?
asked by: Bill H
0
Expert Reply:
Yes the Hitch Ball with 2" Diameter and Short Shank, item # 19258, would be a good match for a Curt Class I Trailer Hitch.
expert reply by:
Robert G
0
Product Page this Question was Asked From
2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: Can A Class III Ball Mount Be Used On a Class II Hitch
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: Parts Needed to Install 7-Way and Brake Controller 2024 Toyota Grand Highlander
- Q&A: Picture of Trailer Hitch Installed on a 2016 Mazda CX-3
- Q&A: Trailer Hitch Receiver & Towing Set Up For Lexus 2006 IS 250
- Q&A: Recommended Equipment for Flat Towing 2013 Ford C-Max Behind Motorhome