What Replacement Hardware do I Need for My Yakima Bolt TopLoader for My Camper Shell?
Question:
I have a Yakima top loader on my camper top with Raingutter 1a s attached…I need to replace one of the original bolts and push nuts….are they available and if not do you have the dimensions of the bolts…thread diameter etc? Thx
asked by: David D
0
Expert Reply:
For your discontinued Yakima Bolt Top Loader that is installed on your camper top, I confirmed with my tech at Yakima that the part you need is the Replacement Mounting Bracket Hardware Kit for Yakima Bolt TopLoader 1992 and Newer # 8880025. Unfortunately, they did not have the exact specs for the threading or the diameter of the bolts on-hand.
expert reply by:
Bob C
0
Product Page this Question was Asked From
Replacement Mounting Bracket Hardware Kit for Yakima Bolt TopLoader 1992 and Newer
- Accessories and Parts
- Roof Rack
- Mounting Hardware
- Brackets
- Yakima
more information >
Continue Researching
- Q&A: Camper Shell Roof Rack Track System For ARE Z Camper Shell To Mount Roof Top Tent
- Q&A: Bolt Size that Comes with Replacement Capnuts, Washers and Bolts for Yakima # Y8810155
- Q&A: Can Yakima Tracks Be Cut to Install on 2014 Honda CR-V Bare Roof
- Q&A: Yakima PlusNut Thread Dimensions
- Q&A: Parts Needed to Install the PlusNut Hardware for Yakima Roof Racks on a Fiberglass Roof
- Q&A: Can Yakima Y01135 Roof Tracks Be Used on Roof of Polaris RZR
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: Rooftop Cargo Carriers
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Trailer Hitch Drop