How Do I Run My Backup Lights from the Trailer into My Cab of My 2000 Peterbuilt?
Question:
Im trying to see how to run wires from backup lights on the trailer into the cab to a switch and it will connect and disconnect when I unhook my trailer
asked by: Jason
0
Expert Reply:
In order to run the backup light into the cab, all you need is the Curt Trailer Connector Adapter - 4-Way Flat to 5-Way Flat - Vehicle End # C57187. This harness will allow you to convert your 4-way harness to a 5-way with the additional backup light pin.
If you currently have a 7-way installed, I recommend routing some spare wire from the reverse signal on your 2000 Peterbilt to the 7 way and then into the trailer's reverse lights.
expert reply by:
Bob C
0
Product Page this Question was Asked From
Curt Trailer Connector Adapter - 4-Way Flat to 5-Way Flat - Vehicle End
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 4 Flat
- Plug and Lead
- 5 Flat
- CURT
more information >
Continue Researching
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Could Demco Actuator part # DM72VR be Manually Locked Out with Rod
- Article: Trailer Wiring Diagrams
- Q&A: Availability of Trailer Hitch and Wiring for 2020 Ford Transit T350 With Extended High Roof
- Q&A: Recommended Replacement Reverse Lockout Solenoid for a Demco DA70 Actuator
- Q&A: Replacement Actuator for 1997 Four Winns Boat Trailer
- Q&A: Connecting A 5-Flat Connector To A 2023 Jeep Grand Cherokee
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)