Replacement Mounting Hardware for Thule Adventurer to Fit Yakima RailBars
Question:
Hello, I have an old Thule Adventurer with a 2inch U-clamp. Id like to mount it on a set of Yakima RailBars, but the U bolt is not wide enough to fit around the Yakimas. Is there a way I can get the Adventurer mounted to these crossbars? Thanks
asked by: Kyle D
0
Expert Reply:
The Replacement QM3 - Quick Mount Hardware - for Adventurer Cargo Box # TH04997 has brackets with mounting holes that measure 4" center to center.
It sounds like you have the Yakima crossbars which measure 3-1/2" wide. Based on this information, you will be able to mount the Thule Adventurer on your rack if you use the Replacement quick mount hardware.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Replacement QM3 - Quick Mount Hardware - for Adventurer Cargo Box
- Accessories and Parts
- Roof Box
- Mounting Hardware
- Thule
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Mounting Hardware For An Older Thule Summit Cargo Box
- Q&A: How Does the Thule Adventurer Cargo Box Install Using the QM3 - Quick Mount Hardware
- Q&A: Complete Mounting Hardware for Thule Evolution 1600 6410 Rooftop Cargo Box
- Q&A: Replacement Mounting Hardware for Thule Mountaineer Cargo Box
- Q&A: What is the Correct Mounting Hardware for a Thule Weekender Cargo Box for a 1998 Toyota 4Runner
- Q&A: How to Tell the Difference Between and Older Model Thule Mountaineer and an Older Model
- Q&A: Installation Instructions for the Thule QM3 Quick On-Off Mounting Hardware Kit # TH04997
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Motorhome Steps
- Article: How to Tie Down Skis and Snowboards to a Roof Rack
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: Trailer Tire Sizing
- Article: What is Overlanding? How to Start your Overlanding Journey