What Hardware Is Used To Mount The Replacement Slide-Out Hex Bar Extension Bracket To The Wall
Question:
My particular installation only had room for this bracket to avoid major modification of the newer two piece version. What screws were used to install these to the wall? I deduced #10 16 stainless, but, were they phillups or hex head and what length. My guess is 1 1/4 but dont want to put holes into the inside wall. Adding this information to the website would help as I am unable to find it.
asked by: Charles W
Helpful Expert Reply:
According to the Lippert installation manual, the Replacement Slide-Out Hex Bar Extension Bracket for Solera Slide # LC2724412 is secured to the wall using #10-16-1 1/4" self tapping screws.
Product Page this Question was Asked From
Replacement Bracket for pre-2019 Solera RV Slide-Out Awnings - Black - Qty 1
- Accessories and Parts
- RV Awnings
- Mounting Hardware
- Brackets
- Solera Replacement
- Black
- Lippert
more information >
Continue Researching
- Q&A: Parts Needed To Install Solera Awning Fabric On Slide-Out
- Q&A: Size of Mounting Screws Solera Slide Topper Mounting Hardware
- Q&A: Instructions For Replacing Solera Slide Topper Awning Hardware
- Q&A: Recommended MORryde Pin Box to Replace a Rhino Box
- Q&A: Which Slide-Out Awning for Slide-Out That is 71-1/4 Inches Wide
- Q&A: Replacement Brackets and Rails for Solera Awning
- Q&A: Tripod Stabilizer for Fifth Wheel Pin Box with Andersen Ultimate Connection Adapter
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
- Article: How to Install an RV Awning From Scratch
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft