How Does Replacement Synthetic Rope Attach To The Drum Of A ComeUp Winch?
Question:
How does this rope attach to the winch drum?
asked by: Jeremy B
Expert Reply:
I spoke with ComeUp and getting the Replacement Synthetic Rope for ComeUp Seal Gen2 and DV Winches # CU98XR installed is a little bit of a process. Not overly difficult, but a few steps to follow to make sure it is secure. I have said steps listed out below:
1. Remove the Allen screw holding your current rope in place.
2. Remove all the old rope, cutting it if needed to quicken the process.
3. Feed in the new rope and secure with the same Allen screw.
4. Fold over enough rope to cover the width of the drum (typically 9" to 10" of the new rope).
5. Secure in this position with electrical tape.
6. Spool up the new rope.
So there are a few steps, but it shouldn't take more than 10 or 15 minutes to complete.
![Lazer S](https://images.etrailer.com/static/images/catg/people/842_tn.jpg)
Product Page this Question was Asked From
Replacement Synthetic Rope for ComeUp Seal Gen2 and DV Winches - 3/8" x 100'
- Accessories and Parts
- Electric Winch
- Ropes
- Synthetic Rope
- ComeUp
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Activate Trailer 12V Power Feed on Factory 7-Way in 2016 Silverado
- Q&A: Operation Instructions for ST Tire Speed Ratings