Availability of Hub That Fits TruRyde Replacement EZ Lube #84 Round Spindle

Question

Question:

Do you have the Hub to fit this spindle?

asked by: Ron G

0

Expert Reply:

We do have hubs that fit the #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axles # TRU77FR. However, the correct hub will depend on what you are looking for exactly. This spindle uses a # L68149 inner bearing and # L44649 outer bearing.

If you are looking for a hub and drum assembly you could use the # AKHD-545-35-EZ-K which has a 5 on 4-1/2 bolt pattern or the # AKHD-655-35-EZ-K with a 6 on 5-1/2 bolt pattern. If you are just looking for an idler hub you could use something like the # 84545UC1-EZ. It all depends on what you are specifically looking for and the bolt pattern you need.

I have attached some review videos along with a link to all of our available hubs that use these bearings for 3,500 lb axles that you can check out.

expert reply by: Robin H

0

Answer 1

We don't a trailer tire size that fits an 8 inch wide 15 inch diameter wheel, but it's possible you are measuring the width and including the mounting lip of the wheel which adds an inch. If that is the case you'd actually have a 7 inch…

view full answer...

Answer 2

The TruRyde #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axles item #TRU77FR has a 3" inner diameter. The E-Z Lube spindle welds onto your 3,500-lb trailer axle it works with L68149 inner bearing and L44649 outer bearing. The Stub…

view full answer...

Answer 3

It all depends on if your tire is compatible with an 8" wide rim. Typically we see that 225/75-15 tires fit 6", 6-1/2", and 7" wheels, but you just need to verify that your specific tire is compatible with your wheel width. If you…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 7

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 8

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 9

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Availability of Hub That Fits TruRyde Replacement EZ Lube #84 Round Spindle

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching