Will The Taylor Made Dock Pro Heavy Duty Bumper Mount To A 4x4 Post
Question:
I see that these measure 5 inches wide . Is it possible to use this on a 4x4 post . I dont mind if it goes past post , just want to make sure I am able to fasten to 4x4
asked by: Mark S
Expert Reply:
The Taylor Made Dock Pro Heavy Duty Dock Bumper - Edge Mount - 35-1/2" Long - White Vinyl # 36945500 does measure 5" wide with the mounting holes being approximately 1/2" from the edge. There is a rounded divot from the 1" mark to the 4" mark so if mounting this vertically I would also use some sort of rope or a large zip tie to prevent the wind from catching the portion that overhangs your 4x4 post and pulling on the screws.
Product Page this Question was Asked From
Taylor Made Dock Pro Heavy Duty Dock or Post Bumper - 35-1/2" Long - White Vinyl
- Boat Dock Bumpers
- Dock Bumpers
- Straight Bumper
- Vinyl
- 0 - 5 Inch Wide
- 3 - 5 Feet Long
- White
- Taylor Made
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Solution to Replace WFCO 8735P to Charge Lithium Batteries
- Q&A: Replacement 3 Terminal Rocker Switch for RV Stairs
- Article: Best Boat Accessories
- Q&A: Are Replacement Parts Available for Kwikee Steps Made in 1989
- Q&A: Where to Measure on a Scissor Jack to Determine if it Will Fit on a Trailer
- Q&A: Replacing Lippert 5,200 lb Axle with Dexter 5,200 lb Axle 86.5 Inches Hub Face to Hub Face
- Q&A: What Hardware Should be Used to Install CIPA Retractable Dock Cleat
- Q&A: Lithium Compatible Replacement for WFCO WF-8735 RV Power Converter
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: What Exactly is Tongue Weight?
- Article: Don't Break Your Pipes or Your Wallet: Winterize and De-Winterize Your RV