What Are The Bolt Hole Dimensions On The EJ-3520-BBX Jack Mounting Plate?
Question:
Is anyone able to provide the spacing between the bolt holds center-to-center, ish, between any two bolt holes and the diameter of the tube?
asked by: Andrew
1
Helpful Expert Reply:
The diameter of the outer tube of the etrailer.com Electric Jack w/ Footplate # EJ-3520-BBX will be the standard 2-1/4". This also follows the standard 3" center to center of the mounting holes, so there are no issues mounting this on just about any trailer. These holes are elongated just in case this off by a little bit, but I did include a diagram for you to check out as well.
expert reply by:
Lazer S
1
Product Page this Question was Asked From
Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Q&A: Troubleshooting Curt Echo Brake Controller Not Getting Power/Not Connecting to iPhone
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Article: Best Bike Racks for Electric Bikes
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Lift Motor for Fantastic Vent in 2002 Teton 5th-Wheel Trailer
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Q&A: Can 2019 GMC Sierra 1500 Denali be Flat Towed and Parts Needed
- Q&A: Trailer Hitch Recommendation for Towing Jet Ski Trailer with a 2017 Hyundai Elantra
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Charge a Dump Trailer Battery
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)